中文
English
Punch equipment manufacturers use compressed air to produce high-pressure gas as a power source. The high-pressure gas then enters the cylinder through an electromagnetic valve, driving the piston to transmit to the main shaft, causing it to move downward and thus creating a force. The movement of the small punch slider is driven by the flywheel of the pneumatic clutch, which drives the crankshaft, connecting rod, and slider to work. Thus forming the back and forth movement of the slider. The motion of the slider is mandatory, and at the same rotational speed, the number of strokes and motion curve of the slider are fixed and unchanged.
Punching equipment manufacturers cause separation or deformation of sheet metal during high-speed stamping of stamping dies. A punching die consists of an upper die and a lower die. The handle of the upper mold is fixed on the slider of the pneumatic punch press As the slider moves up and down, the lower die is fixed on the worktable of the punch press. The punch and die are fixed on the upper and lower templates respectively with pressure plates. The upper and lower templates are equipped with guide sleeves and guide columns to guide the punch and die to align and deform or separate the working parts of the billet. The guide plate and positioning pin are respectively used to control the feeding direction and feeding length of the billet. The function of the discharge plate is to release the workpiece or blank from the punch after stamping.
The working principle of punching equipment manufacturers:
The design principle of a punch press is to convert circular motion into linear motion, which is driven by the main motor to drive the flywheel. The clutch drives the gears, crankshaft, connecting rod, etc. to achieve linear motion of the slider. The motion from the main motor to the connecting rod is circular motion.
Equipment operating procedures of punching equipment manufacturers:
1. Before starting work, check the stamping work area for any unrelated workpieces or debris. After removing them, inspect the upper and lower molds and screws for looseness. If the molds are loose, they must be reassembled.
2. Check the operation mode of the punch press, whether it is single manual, manual or foot operated. Place the switch handle in the selected mode. Our company does not currently require linkage mode for processing, so it is not allowed to be placed in the linkage position.
3. When abnormal problems are discovered, such as abnormal sounds, the main power must be turned off before troubleshooting or repairing.
4. When
